1. 取出說明書, 仔細閱讀它.
2.
檢查螺絲釘和螺帽.
放在一個容器內, 以防遺失.
3. 用提供的膠水將沙拉碗和塑料板黏貼在一起(需要2小時才能乾).
4. 使用短螺絲釘(b1)和螺帽(c1)把D裝到C上.
5.
使用長螺絲釘(b)把A裝到C上.
6. 連接四管(E)成為二樑.使用螺絲釘(a)固定.
7.使用長螺絲釘(b) 把一樑裝到二 A上 (穿過D). 確保 A上的按鍵朝裡面.
8. 連接6小桿為3長桿. 並穿過塑料板(見第3步) (並拿掉塑料板保護膜) (可不必穿過上面兩孔, 而用短繩調整塑料板斜度)
9. 把二 F 連接到3長桿上.
10.
使用長螺絲釘(b) 把另一樑裝到 B 和 F.
確保在 B上的按鍵洞朝裡面.(可能需要WD40潤滑劑)
11.把二 B裝到二 A 上. 用在 B中最外面的按鍵洞 .
12. 把圓布裝到碗上.
13. 把長布裝到塑料板及 二 F上.
14. 調整背景燈光線, 需要投射聚焦在幢頂圓型反射罩(沙拉碗) 中心上方與圓邊一半之處。
註: 下面四個輪子都有煞車, 壓下即可煞住。
1. Take out instruction sheet and read it carefully.
2. Check the screws and nuts. Put them into a container such that they will not get lost .
3. Glue the salad bowl with the plastic plate together with the glue supplied (It takes 2 hours to dry) .
4. Use short screws (b1) and caps (c1) to attach D to C .
5. Use long screws (b) to attach A to C .
6. Connect four tubes (E) into two beam. Use screw (a) to lock them.
7. Attach one beam to two As (Use long screws (b) thru D). Make sure that the button on A is facing inside.
8. Connect 6 small rods into 3 long rods. Thread two of the long rods thru the plastic plate assembly in Step 3. (Connect two rods in the middle by screwing one to the other. )
9. Attach two Fs to the 3 long rods.
10. Attach two Bs and the other beam to two Fs. (Use long screws (b)). Make sure that the button holes on B is facing inside. (May need WD40 lubricant)
11. Attach two Bs to two As. Use the outmost hole in B.
12. Attach the round cloth to the bowl.
13. Attach the long cloth to the top assembly.
14. Adjust the light to shine on the top 2/3 of bowl.